HPE FlexNetwork MSR Series - Ani; Antenna Type

2
Predefined user roles
network-admin
Usage guidelines
This command is applicable only to 802.11n radios. Changing the radio mode to 802.11a, 802.11b, or
802.11g invalidates the command.
The device can receive but cannot send A-MSDUs.
Examples
# Disable the A-MSDU aggregation method.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] type dot11an
[Sysname-WLAN-Radio0/0] a-msdu disable
ani
Use ani enable to enable Adaptive Noise Immunity (ANI).
Use ani disable to disable ANI.
Use undo ani to restore the default.
Syntax
ani { disable | enable }
undo ani
Default
ANI is enabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
ANI enables the device to adjust the anti-noise level based on the environment to reduce
interference from the surrounding environment.
Examples
# Enable ANI.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] ani enable
antenna type
Use antenna type to set the antenna type for an AP.
Use undo antenna type to restore the default.
Syntax
antenna type antenna-type