20
Predefined user roles
network-admin
Usage guidelines
This command is applicable only to 802.11n radios. Changing the radio mode to 802.11a, 802.11b, or
802.11g invalidates the command.
Examples
# Disable short GI.
<Sysname> system-view
[Sysname] interface wlan-radio 0/1
[Sysname-WLAN-Radio0/1] short-gi disable
short-retry threshold
Use short-retry threshold to set the maximum number of hardware retransmissions for small
frames.
Use undo short-retry threshold to restore the default.
Syntax
short-retry threshold count
undo short-retry threshold
Default
The maximum number of hardware retransmissions is 7 for small frames.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
count: Specifies the maximum number of hardware retransmissions for small frames, in the range of
1 to 15.
Usage guidelines
Small frames are frames smaller than or equal to the RTS threshold. If a radio fails to transmit a
packet when the maximum number of hardware retransmissions is reached, the AP selects another
transmission rate for the packet. The radio uses the new rate to transmit the packet again.
Examples
# Set the maximum number of hardware retransmissions to 10 for small frames.
<Sysname> system-view
[Sysname] interface wlan-radio 0/1
[Sysname-WLAN-Radio0/1] short-retry threshold 10
Related commands
long-retry threshold
smart-antenna
Use smart-antenna enable to enable the smart antenna feature.
To Next Page
Loading...
Need help?
General
