27
Use undo measure to restore the default.
Syntax
measure { all | link | neighbor | radio | spectrum | tpc } { disable | enable }
undo measure
Default
Measurement is disabled.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
all: Specifies all measurement features.
link: Specifies link measurement. Link measurement measures RCPI, RSNI, and link redundancy
for the requested link.
neighbor: Specifies neighbor measurement. Neighbor measurement measures the channel and
BSSID of neighbor APs.
radio: Specifies radio measurement. Radio measurement measures channel load, noise histogram,
beacons, frames, station statistics, locations, and transmit streams.
spectrum: Specifies spectrum measurement, which includes basic measurement, Clear Channel
Assessment (CCA) measurement, and Receive Power Indication (RPI) measurement. This keyword
is supported only on 5 GHz radio interfaces.
tpc: Specifies TPC measurement. TPC measurement measures link redundancy and transmission
power for clients. This keyword is supported only on 5 GHz radio interfaces.
Usage guidelines
You must enable radio resource measurement if you enable link, neighbor, or radio measurement.
You must enable spectrum management if you enable spectrum or TPC measurement.
Examples
# Enable spectrum measurement.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] measure spectrum enable
Related commands
measure-duration
measure-interval
resource-measure
spectrum-management
measure-duration
Use measure-duration to set the measurement duration.
Use undo measure-duration to restore the default.
To Next Page
Loading...
Need help?
General
