29
Examples
# Set the measurement interval to 35 seconds.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] measure-interval 35
Related commands
measure
measure-duration
resource-measure
Use resource-measure enable to enable radio resource measurement.
Use resource-measure disable to disable radio resource measurement.
Use undo resource-measure to restore the default.
Syntax
resource-measure { disable | enable }
undo resource-measure
Default
Radio resource measurement is disabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
When radio measurement is enabled on the AP, the AP sets the Radio Measurement field to 1 in
beacons, probe responses, association responses, or reassociation responses. It notifies the clients
that the AP supports 802.11k and they can send 802.11k measurement requests.
The AP periodically sends Measurement Pilot frames to help clients fast discover the AP.
Measurement Pilot frames are sent more frequently than beacons and carry less information.
Examples
# Enable radio resource measurement.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] resource-measure enable
rm-capability mode
Use rm-capability mode to set the match mode for client radio resource measurement capabilities.
Use undo rm-capability mode to restore the default.
Syntax
rm-capability mode { all | none | partial }
undo rm-capability mode
To Next Page
Loading...
Need help?
General
