298
Syntax
user-role role-name
undo user-role role-name
Default
A monitor policy contains user roles that its creator had at the time of policy creation.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
role-name: Specifies a user role by its name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
For EAA to execute an action in a monitor policy, you must assign the policy the user role that has
access to the action-specific commands and resources. If EAA lacks access to an action-specific
command or resource, EAA does not perform the action and all the subsequent actions.
For example, a monitor policy has four actions numbered from 1 to 4. The policy has user roles that
are required for performing actions 1, 3, and 4, but it does not have the user role required for
performing action 2. When the policy is triggered, EAA executes only action 1.
A monitor policy supports a maximum of 64 valid user roles. User roles added after this limit is
reached do not take effect.
You cannot assign a monitor policy user roles that have higher privilege than the user roles you are
logged in with.
Examples
# Assign user roles to a CLI-defined policy.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] user-role network-admin
[Sysname-rtm-test] user-role admin
To Next Page
Loading...
Need help?
General
