HPE FlexNetwork MSR3012 User Manual

67
source interface
Use source interface to specify the IP address of the specified interface as the source IP address of
probe packets.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number
undo source interface
Default
No source IP address is specified for probe packets. The probe packets take the primary IP address
of the outgoing interface as their source IP address.
Views
ICMP echo operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you execute this command and the source ip or source ipv6 command for an ICMP echo
operation multiple times, the most recent configuration takes effect.
If you execute this command and the source ip command for a UDP tracert operation multiple times,
the most recent configuration takes effect.
The specified source interface must be up. Otherwise, no probe requests can be sent out.
Examples
# Specify the IP address of interface GigabitEthernet 1/0/1 as the source IP address of ICMP echo
request packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface gigabitethernet 1/0/1
Related commands
source ip
source ipv6
source ip
Use source ip to configure the source IPv4 address for probe packets.
Use undo source ip to restore the default.
Syntax
source ip ip-address
undo source ip

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English