96
[Sysname] ntp-service authentication enable
[Sysname] ntp-service authentication-keyid 10 authentication-mode md5 simple BetterKey
Related commands
ntp-service authentication enable
ntp-service reliable authentication-keyid
ntp-service broadcast-client
Use ntp-service broadcast-client to configure the device to operate in NTP broadcast client mode
and use the current interface to receive NTP broadcast packets.
Use undo ntp-service broadcast-client to remove the configuration.
Syntax
ntp-service broadcast-client
undo ntp-service broadcast-client
Default
The device does not operate in any NTP association mode.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
After you configure the command, the device listens to NTP messages sent by the NTP broadcast
server and is synchronized based on the received NTP messages.
If you have configured the device to operate in broadcast client mode on an interface with the
command, do not add the interface to any aggregate group. To add the interface to an aggregate
group, remove the configuration of the command.
Examples
# Configure the device to operate in broadcast client mode and receive NTP broadcast messages on
GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ntp-service broadcast-client
Related commands
ntp-service broadcast-server
ntp-service broadcast-server
Use ntp-service broadcast-server to configure the device to operate in NTP broadcast server
mode and use the current interface to send NTP broadcast packets.
Use undo ntp-service broadcast-server to remove the configuration.
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
To Next Page
Loading...
Need help?
General
