HPE FlexNetwork MSR3012 User Manual

266
Related commands
cwmp acs password
cwmp cpe connect interface
Use cwmp cpe connect interface to specify the CWMP connection interface.
Use undo cwmp cpe connect interface to restore the default.
Syntax
cwmp cpe connect interface interface-type interface-number
undo cwmp cpe connect interface
Default
No CWMP connection interface is specified. The CPE automatically selects the CWMP connection
interface.
Views
CWMP view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the type and number of the CWMP connection interface.
Usage guidelines
A CWMP connection interface is the interface that the CPE uses to communicate with the ACS. To
establish a CWMP connection, the CPE sends the IP address of this interface in the Inform
message, and the ACS replies to this IP address.
If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address
on the device, you do not need to specify the CWMP connection interface.
If the CPE has multiple Layer 3 interfaces, specify the interface that connects to the ACS as the
CWMP connection interface. This manual setting prevents incorrect CWMP connection interface
selection, which might occur with automatic selection.
Examples
Specify GigabitEthernet 1/0/1 as the CWMP connection interface.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect interface gigabitethernet 1/0/1
cwmp cpe connect retry
Use cwmp cpe connect retry to set the maximum number of attempts the CPE can make to retry a
failed CWMP connection.
Use undo cwmp cpe connect retry to restore the default.
Syntax
cwmp cpe connect retry retries
undo cwmp cpe connect retry

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English