HPE FlexNetwork MSR3012

422
Overwritten messages: 0
Current messages: 127
%Jun 19 18:03:24:55 2006 Sysname SYSLOG/7/SYS_RESTART:System restarted
…
Table 89 Command output
Field
Description
Log buffer
• Enabled—Logs can be output to the log buffer.
• Disabled—Logs cannot be output to the buffer.
Max buffer size Maximum buffer size supported by the device.
Actual buffer size
Maximum buffer size configured by using the
info-center logbuffer size
command.
Dropped messages Number of dropped messages.
Overwritten messages Number of overwritten messages.
Current messages Number of current messages.
Related commands
info-center logbuffer
reset logbuffer
display logbuffer summary
Use display logbuffer summary to display the summary of the log buffer.
Syntax
Centralized devices in standalone mode:
display logbuffer summary [ level severity ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display logbuffer summary [ level severity | slot slot-number ] *
Distributed devices in IRF mode:
display logbuffer summary [ level severity | chassis chassis-number slot slot-number ] *
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
level severity: Specifies a severity level in the range of 0 to 7. If you do not specify a severity level,
this command displays log information of all levels in the log buffer. For more information about log
levels, see Table 88.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays information for all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays information for all member devices. (Centralized devices in IRF
mode.)