HPE FlexNetwork MSR3012 User Manual

47
Parameters
get: Gets a file from the FTP server.
put: Transfers a file to the FTP server.
Usage guidelines
When you perform the put operation with the filename command configured, make sure the file
exists on the NQA client.
If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP server.
The NQA client does not save the file obtained from the FTP server.
Use a small file for the FTP operation. A big file might result in transfer failure because of timeout, or
might affect other services for occupying much network bandwidth.
Examples
# Set the operation type to put for the FTP operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type ftp
[Sysname-nqa-admin-test-ftp] operation put
Related commands
password
username
operation (HTTP operation view)
Use operation to specify the operation type for the HTTP operation.
Use undo operation to restore the default.
Syntax
operation { get | post | raw }
undo operation
Default
The HTTP operation type is get.
Views
HTTP operation view
Predefined user roles
network-admin
Parameters
get: Gets data from the HTTP server.
post: Transfers data to the HTTP server.
raw: Sends the RAW request to the HTTP server.
Usage guidelines
The HTTP operation use HTTP requests as probe packets.
For the get or post operation, the content in the request is obtained from the URL specified by the url
command.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English