HPE FlexNetwork MSR3012

278
When you define an action, you can specify a value or specify a variable name for an argument. For
more information about using EAA environment variables, see "rtm environment."
Examples
# Configure the CLI-defined policy test to shut down GigabitEthernet 1/0/1 when the policy is
triggered.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 1 cli system-view
[Sysname-rtm-test] action 2 cli interface gigabitethernet 1/0/1
[Sysname-rtm-test] action 3 cli shutdown
action reboot
Use action reboot to add a reboot action to a monitor policy.
Use undo action to remove an action.
Syntax
Centralized devices in standalone mode:
action number reboot
undo action number
Distributed devices in standalone mode/centralized devices in IRF mode:
action number reboot [ slot slot-number [ subslot subslot-number ] ]
undo action number
Distributed devices in IRF mode:
action number reboot [ chassis chassis-number [ slot slot-number [ subslot subslot-number ] ] ]
undo action number
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
chassis chassis-number: Specifies an IRF member device by its member ID. If you do not specify a
member device, the command reboots all IRF member devices. (Distributed devices in IRF mode.)
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
reboots all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
reboots all cards. (Distributed devices in IRF mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, the command reboots all IRF member devices. (Centralized devices in IRF mode.)
subslot subslot-number: Specifies a subcard by its slot number. If you do not specify a subcard, the
command reboots all subcards.