HPE FlexNetwork MSR3012 User Manual

2
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
module-name: Specifies a module by its name. For a list of supported modules, use the display
debugging ? command. If you do not specify a module name, this command displays the enabled
debugging features for all modules.
Examples
# Display all enabled debugging features.
<Sysname> display debugging
DEV debugging switch is on
Related commands
debugging
ping
Use ping to test the reachability of the destination IP address and display ping statistics.
Syntax
ping [ ip ] [ -a source-ip | -c count | -f | -h ttl | -i interface-type interface-number | -m interval | -n | -p
pad | -q | -r | -s packet-size | -t timeout | -tos tos | -v | { -topology topo-name | -vpn-instance
vpn-instance-name } ] * host
Views
Any view
Predefined user roles
network-admin
Parameters
ip: Distinguishes between a destination host name and the ping command keywords if the name of
the destination host is i, ip, ipv, or ipv6. For example, you must use the command in the form of ping
ip ip instead of ping ip if the destination host name is ip.
-a source-ip: Specifies an IP address of the device as the source IP address of ICMP echo requests.
If this option is not specified, the source IP address of ICMP echo requests is the primary IP address
of the outbound interface.
-c count: Specifies the number of ICMP echo requests that are sent to the destination. The value
range is 1 to 4294967295, and the default is 5.
-f: Sets the "do-not-fragment" bit in the IP header.
-h ttl: Specifies the TTL value of ICMP echo requests. The value range is 1 to 255, and the default is
255.
-i interface-type interface-number: Specifies the source interface for ICMP echo requests. If you do
not specify this option, the system uses the primary IP address of the matching route's egress
interface as the source interface for ICMP echo requests.
-m interval: Specifies the interval (in milliseconds) to send ICMP echo requests. The value range is 1
to 65535, and the default is 200.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English