143
Use undo poe legacy enable to disable the PSE from detecting nonstandard PDs.
Syntax
poe legacy enable pse pse-id
undo poe legacy enable pse pse-id
Default
Nonstandard PD detection is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
pse pse-id: Specifies a PSE by its ID.
Examples
# Enable PSE 7 to detect nonstandard PDs.
<Sysname> system-view
[Sysname] poe legacy enable pse 7
Related commands
display poe pse
poe max-power
Use poe max-power to set the maximum PI power.
Use undo poe max-power to restore the default.
Syntax
poe max-power max-power
undo poe max-power
Default
The maximum PI power is 15400 milliwatts.
Views
PI view
PoE profile view
Predefined user roles
network-admin
Parameters
max-power: Sets the maximum PI power in milliwatts.
Examples
# Set the maximum PI power to 12000 milliwatts in PI view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] poe max-power 12000
To Next Page
Loading...
