HPE FlexNetwork MSR3012

81
NTP commands
NTP is supported on the following Layer 3 interfaces:
•
Layer 3 Ethernet interfaces.
•
Layer 3 Ethernet subinterfaces.
•
Layer 3 aggregate interfaces.
•
VLAN interfaces.
•
Tunnel interfaces.
display ntp-service ipv6 sessions
Use display ntp-service ipv6 sessions to display information about all IPv6 NTP associations.
Syntax
display ntp-service ipv6 sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information about all IPv6 NTP associations. If you do not specify this
keyword, the command displays only brief information about the IPv6 NTP associations.
Examples
# Display brief information about all IPv6 NTP associations.
<Sysname>display ntp-service ipv6 sessions
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Source: [125]3000::32
Reference: 127.127.1.0 Clock stratum: 2
Reachabilities: 1 Poll interval: 64
Last receive time: 6 Offset: -0.0
Roundtrip delay: 0.0 Dispersion: 0.0
Total sessions : 1
Table 13 Command output
Field
Description
[12345]
• 1—Clock source selected by the system (
the current reference
source).
• 2—The stratum level of the clock source is less than or equal to 15.
• 3—The clock source has survived the clock selection algorithm.
• 4—The clock source is a candidate clock source.
• 5—The clock source was created by a command.