HPE FlexNetwork MSR3012 User Manual

72
Syntax
target-only
undo target-only
Default
NQA performs the path jitter operation to the destination hop by hop.
Views
Path jitter operation view
Predefined user roles
network-admin
Examples
# Perform the path jitter operation only on the destination address.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type path-jitter
[Sysname-nqa-admin-test-path-jitter] target-only
tos
Use tos to set the ToS value in the IP header for probe packets.
Use undo tos to restore the default.
Syntax
tos value
undo tos
Default
The ToS value in the IP header of probe packets is 0.
Views
Any operation view
Predefined user roles
network-admin
Parameters
value: Specifies the ToS value in the range of 0 to 255.
Examples
# In ICMP echo operation view, set the ToS value to 1 in the IP header for probe packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] tos 1
ttl
Use ttl to set the maximum number of hops that the probe packets can traverse.
Use undo ttl to restore the default.

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English