EasyManuals Logo

HPE FlexNetwork MSR3012 User Manual

HPE FlexNetwork MSR3012
475 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #269 background imageLoading...
Page #269 background image
259
Before you execute this command, configure the authentication mode for users as scheme on the
device. Then, the NETCONF-over-SSH-enabled user terminals can access the device through
NETCONF over SSH.
Only capability set urn:ietf:params:netconf:base:1.0 is available. It is supported by both the device
and user terminals.
Examples
# Enable NETCONF over SSH.
<Sysname> system-view
[Sysname] netconf ssh server enable
netconf ssh server port
Use netconf ssh server port to specify a port to listen for NETCONF over SSH connections.
Use undo netconf ssh server port to restore the default.
Syntax
netconf ssh server port port-number
undo netconf ssh server port
Default
Port 830 listens for NETCONF over SSH connections.
Views
System view
Predefined user roles
network-admin
Parameters
port-number: Specifies a port by its number in the range of 1 to 65535.
Usage guidelines
When assigning a listening port, make sure the specified port is not being used by other services.
The SSH service can share the same port with other services, but it might not operate correctly.
Examples
# Specify port 800 to listen for NETCONF over SSH connections.
<Sysname> system-view
[Sysname] netconf ssh server port 800
xml
Use xml to enter XML view.
Syntax
xml
Views
User view
Predefined user roles
network-admin

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork MSR3012 and is the answer not in the manual?

HPE FlexNetwork MSR3012 Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork MSR3012
CategoryNetwork Router
LanguageEnglish

Related product manuals