280
Default
Monitor policies do not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
You can configure a series of actions to be executed in response to the event specified in a monitor
policy. EAA executes the actions in ascending order of action IDs. When you add actions to a policy,
you must make sure the execution order is correct. If two actions have the same ID, the most recent
one takes effect.
(Centralized devices in standalone mode.) This command does not trigger an active/standby
switchover.
(Distributed devices in standalone mode.) This command does not trigger an active/standby
switchover in either of the following situations:
The device has only one MPU.
The standby MPU is not in up state.
(Centralized devices in IRF mode.) This command does not trigger an active/standby switchover in
either of the following situations:
No subordinate device is configured.
The subordinate device is not in up state.
(Distributed devices in IRF mode.) This command does not trigger an active/standby switchover in
either of the following situations:
No global standby MPU is configured.
The global standby MPU is not in up state.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover
action syslog
Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.
Syntax
action number syslog priority priority facility local-number msg msg-body
undo action number
Default
Monitor policies do not contain any actions.
To Next Page
Loading...
Need help?
General
