HPE FlexNetwork MSR3012

134
Field
Description
Detection Status
Power detection status of a PI:
• Disabled—PoE function is disabled.
• Searching—The PI is searching for the PD.
• Delivering Power—The PI is supplying power to the PD.
• Fault—A fault occurred during the test.
• Test—The PI is undergoing a test.
• Other Fault—A fault has caused the PSE to enter the idle status.
• PD Disconnected—The PD is disconnected.
On State Ports Number of PIs that are supplying power.
Used Power consumed by PIs on the PSE.
Remaining Remaining power on the PSE.
display poe pse interface power
Use display poe pse interface power to display power information for PIs on a PSE.
Syntax
display poe pse pse-id interface power
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
pse pse-id: Specifies a PSE by its ID. To display PSE ID and slot mappings, use the display poe
device command.
Examples
# Display power information for PIs on PSE 7.
<Sysname> display poe pse 7 interface power
Interface Current Peak Max PD Description
(W) (W) (W)
GE1/0/25 4.4 4.5 4.6 IP Phone on Room 309 for Peter Smith
GE1/0/26 4.4 4.5 15.4 IP Phone on Room 409 for Peter Pan
GE1/0/27 15.0 15.3 15.4 Access Point on Room 509 for Peter
GE1/0/28 0.0 0.0 5.0 IP Phone on Room 609 for Peter John
GE1/0/29 0.0 0.0 4.0 IP Phone on Room 709 for Jack
GE1/0/30 0.0 0.0 5.0 IP Phone on Room 809 for Alien
--- On State Ports: 3; Used: 23.8(W); Remaining: 776.2(W) ---
Table 28 Command output
Field Description
Interface Interface name of a PI.
Current Current power of a PI.