EasyManuals Logo

HPE FlexNetwork MSR3012 User Manual

HPE FlexNetwork MSR3012
475 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #415 background imageLoading...
Page #415 background image
405
Usage guidelines
Version 9 is template-based and supports user-defined formats. An IPv6 NetStream device must
send the version 9 templates to NetStream servers regularly, because the servers do not
permanently save templates.
You can configure the refresh frequency or refresh interval for the device to send version 9
templates. If both settings are configured, templates are sent when either of the conditions is met.
To configure the refresh interval for version 9 templates, use the ipv6 netstream export
v9-template refresh-rate time command.
Examples
# Configure the device to send IPv6 NetStream version 9 templates every 100 packets.
<Sysname> system-view
[Sysname] ipv6 netstream export v9-template refresh-rate packet 100
Related commands
ipv6 netstream export v9-template refresh-rate time
ipv6 netstream export v9-template refresh-rate time
Use ipv6 netstream export v9-template refresh-rate time to configure the sending interval for
IPv6 NetStream version 9 templates.
Use undo ipv6 netstream export v9-template refresh-rate time to restore the default.
Syntax
ipv6 netstream export v9-template refresh-rate time minutes
undo ipv6 netstream export v9-template refresh-rate time
Default
Version 9 templates are sent every 30 minutes.
Views
System view
Predefined user roles
network-admin
Parameters
minutes: Specifies the interval in the range of 1 to 3600 minutes.
Usage guidelines
Version 9 is template-based and supports user-defined formats. An IPv6 NetStream device must
send the version 9 templates to NetStream servers regularly, because the servers do not
permanently save templates.
You can adjust the refresh frequency or refresh interval for the device to send version 9 templates. If
both settings are configured, templates are sent when either of the conditions is met.
To configure the refresh frequency for version 9 templates, use the ipv6 netstream export
v9-template refresh-rate packet command.
Examples
# Configure the device to send version 9 templates every 60 minutes.
<Sysname> system-view
[Sysname] ipv6 netstream export v9-template refresh-rate time 60

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork MSR3012 and is the answer not in the manual?

HPE FlexNetwork MSR3012 Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork MSR3012
CategoryNetwork Router
LanguageEnglish

Related product manuals