408
Examples
# Set the aging timer to 60 minutes for active flows.
<Sysname> system-view
[Sysname] ipv6 netstream timeout active 60
Related commands
ipv6 netstream timeout inactive
ipv6 netstream timeout inactive
Use ipv6 netstream timeout inactive to set the aging timer for inactive flows.
Use undo ipv6 netstream timeout inactive to restore the default.
Syntax
ipv6 netstream timeout inactive seconds
undo ipv6 netstream timeout inactive
Default
The aging timer is 30 seconds for inactive flows.
Views
System view
Predefined user roles
network-admin
Parameters
seconds: Sets the aging timer for inactive flows, in the range of 10 to 600 seconds.
Usage guidelines
A flow is considered inactive if no packet for the IPv6 NetStream entry arrives before the timer set by
this command expires.
Examples
# Set the aging timer to 60 seconds for inactive flows.
<Sysname> system-view
[Sysname] ipv6 netstream timeout inactive 60
Related commands
ipv6 netstream timeout active
reset ipv6 netstream statistics
Use reset ipv6 netstream statistics to age out all flows in the cache and export IPv6 NetStream
data.
Syntax
reset ipv6 netstream statistics
Views
User view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
