● You have removed the front I/O module. For details, see 5.6.1 Removing the
Front I/O Module.
● You have removed barriers such as the iBBU or supercapacitor support. For
details, see 5.6.7 Removing a Supercapacitor.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a RAID
controller card.
Tools
● ESD gloves
● Phillips screwdriver (M3)
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Press the two buttons on the front I/O module cover. See step (1) in Figure 5-69.
Step 3 Remove the cover from the front I/O module in the arrow direction. See step (2)
in Figure 5-69.
Figure 5-69 Removing a cover from a front I/O module
Step 4 Remove the cables from the RAID controller card. See step (1) in Figure 5-70.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 187
To Next Page
Loading...
