● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a
supercapacitor.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
● Phillips screwdriver
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Press the two buttons on the front I/O module cover. See step (1) in Figure 5-75.
Step 3 Take out the cover of the front I/O module in the arrow direction. See step (2) in
Figure 5-75.
Figure 5-75 Removing a cover from a front I/O module
Step 4 Loosen the screws on both sides of the supercapacitor support. See step (1) in
Figure 5-76.
Step 5 Pull out the supercapacitor support. See step (2) in Figure 5-76.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 193
To Next Page
Loading...
