Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the front I/O module from the RH8100 V3. For details, see
5.8.1 Removing the Front I/O Module.
● You have removed the supercapacitor tray. For details, see 5.8.9 Removing a
Supercapacitor.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing a RAID
controller card.
Tools
● ESD gloves
● M3 Phillips screwdriver
● Packaging materials, for example, an ESD bag
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Remove the cables from the RAID controller card. See step (1) in Figure 5-119.
Step 3 Loosen the screws on the RAID controller card. See step (2) in Figure 5-119.
Step 4 Lift the RAID controller card slowly out of the server. See step (3) in Figure 5-119.
Figure 5-119 Removing a RAID controller card
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 240
To Next Page
Loading...
