Controller Lifting Instructions 7
User Guide v 1.4 — September 2015 Introduction
b. Make sure the straps are not pinching or crushing any cables attached to the
controller.
3. Use the lifting device to apply enough upward force on the straps to remove the slack,
but do not lift the controller at this time.
4. Place the ratchet strap around top of the controller, holding the four ends of the
webbed straps. Do not tighten the ratchet strap at this time.
NOTE:The ratchet strap keeps the controller from tipping when the controller is lifted.
5. Place cloth or other cushioning material between the ratchet strap and the controller to
keep the finish of the controller free from rubs and scratches.
Figure 1-2 Positioning Straps
Figure 1-3 Checking Cables
To Next Page
Loading...
