To Next Page

To Previous Page

62 Error codes, descriptions, and corrective actions

162 Configuration Error

Configuration Change Has

Occurred

• If you are using Rapid Resume, complete the following steps:

- If you have not changed your hardware (installed or removed an option),

check your A Guide to HelpWare and All the Extras folder for information

on obtaining service.

Note: Any work that you did not save before the computer was turned off

cannot be retrieved.

- If you have changed your hardware (installed or removed an option), press

the on/off button on the system unit to turn it off. Return the hardware to its

previous configuration, wait 10 seconds, and then turn the system unit on

again. If the error does not reoccur, save any work that you want to keep

and reinstall your hardware. If the error occurs again, check your A Guide

to HelpWare and All the Extras folder for information on obtaining service.

• If you are not using Rapid Resume:

- Press Enter while the error message is displayed to start the Setup Utility.

Look through the Setup Utility and verify that the options with next to

them were supposed to change. If so, press the Esc key and then press

Enter to save the new settings. Then exit the Setup Utility. For more

information on using the Setup Utility, see page 69. If options changed that

were not supposed to, check your A Guide to HelpWare and All the Extras

folder for information on obtaining service.

163 Date and Time Incorrect The clock module on the system board may not be set correctly. To set the

correct date and time, press Enter while the error message is displayed to

enter the Setup Utility. For instructions on using the Setup Utility, see page 69.

Table 10: Error codes, descriptions, and corrective actions (Continued)

Error Code Description Here’s what to do:

Notes:

1.An X shown as part of the error code in this table represents any number between 0 and 9.

2.If any of these errors continue after taking the actions listed, check your A Guide to HelpWare and All the Extras folder for

information on obtaining service.

bi2gntce.bk : bi2gsolv.doc Page 62 Saturday, June 3, 1995 6:54 AM

IBM Aptiva Hardware Handbook

Other manuals for IBM Aptiva