Icom IC-7800 - Page 127

7-13
7
VOICE RECORDER FUNCTIONS
Select the recording mode for recording a QSO
audio.
•TX&RX:Recordsboththetransmittedandreceived
audio.
•RXonly:Recordsonlythereceivedaudio.
Select whether or not the squelch status affects the
RX voice audio recording.
•Always: Thetransceiveralwaysrecordsthe
RX audio, regardless of the squelch
status.
•SquelchAuto:ThetransceiverrecordstheRXaudio
only when a signal is received (the
squelch is opened).
When the squelch closes while re-
cording, the recording will continue
for 2 seconds, and then pause.
Select a memory device for recording a QSO audio. •CFCARD :RecordstheQSOaudioontotheCF
card.
•USB-Memory:Records the QSO audio onto the
USB flash drive.
Set the desired time period for the one-touch playing
(when [PLAY] is pushed).
•Setbetween3and10seconds(in1secondsteps).
(default: 5 seconds)
Set the desired time period for the for one-touch re-
cording (when [REC] is pushed).
•Setbetween5to30seconds(in1secondsteps).
(default: 15 seconds)
Set the repeat interval for the voice repeat trans-
mission to between 1 and 15 seconds (in 1 second
steps).
The transceiver repeatedly transmits the recorded
voice audio at this interval.