Icom IC-7800 - Page 128

7-14
7
VOICE RECORDER FUNCTIONS
Turn the PTT Automatic Recording function ON or
OFF.
•OFF:Therecordingdoesnotstartevenifasignalis
transmitted.
•ON: Therecordingautomaticallystartswhenasig-
nal is transmitted.
The recording will continue when:
 •Asignalistransmittedagainwithin10seconds
after the last transmission.
 •Asignalisreceivedwithin10secondsafterthe
last transmission, the received audio is also re-
corded.
- A signal is received within 10 seconds after the
last reception.
 •ThesquelchisopenintheFMmodes.
The recording will stop when:
 •Thefrequencyoroperatingmodeischanged.
 •Theoperatingmethod(V/M,M-CH,BandStack-
ing Register, and so on) is changed.
 •10minuteshaspastafterthelasttransmission
while the squelch is open in the SSB, CW, RTTY,
PSK or AM modes.
Set the Skip time for forwarding or rewinding while
playing back the QSO audio.
3, 5, 10 and 30 seconds are selectable.
Turn the File Split function ON or OFF. •OFF:Theaudioiscontinuouslyrecordedintothe
file, even if you switch between transmit and
receive or the squelch status changes be-
tween open and closed.
•ON: While recording,andif youswitchbetween
transmit and receive, or the squelch status
changes between open and closed, a new file
is automatically created in the same folder,
and the audio is saved into the new one.
■ Voice set mode (Continued)