Icom IC-7800 - Page 166

12-10
12
SET MODE
Adjusts the internal reference signal frequency within
0 to 100% range in 1% steps during frequency cali-
bration.
NOTE: The default setting is different for each
transceiver.
Selects the transceiver’s reference signal condition
from IN, OFF and OUT.
•IN :UseanexternalreferencesignalfortheIC-
7800. Turn the transceiver power OFF then
ON to make the setting effective.
•OFF :Notinput/outputthereferencesignal.
(default)
•OUT :OutputstheIC-7800referencesignaltoex-
ternally connected equipment(s) for their
reference.
NOTE: If the applied reference signal is off-fre-
quency, or no signal is applied with “IN” selection,
the IC-7800 will not work properly. Select “OFF” or
“OUT” then reboot the IC-7800 in such case.
■ ACC set mode (continued)
Selects the desired item for an external meter indica-
tion (sub readout).
•Auto :Outputs the receiving signal strength
level during receive, and outputs the se-
lected level (selected with [METER]), dur-
ing transmit. (default)
•S(MAIN):Outputsthereceivingsignalstrengthlevel
during receive.
•Po :Outputsthetransmittingpowerleveldur-
ing transmit.
•SWR :OutputstheVSWRlevelduringtransmit.
•ALC :OutputstheALClevelduringtransmit.
•COMP :Outputs the compression level during
transmit.
•Vd : Outputs the drain terminal voltage of the
final amplifier MOS-FETs.
•Id : Outputs the drain current of the final am-
plifier MOS-FETs.
Sets the output level for an external meter indication
(main readout) with in 0 to 100% range in 1% steps.
•Approximately2.5Vat50%(default)settingforfull-scale
indication. (4.7 kΩ impedance)
Sets the output level for an external meter indication
(sub readout) with in 0 to 100% range in 1% steps.
•Approximately2.5Vat50%(default)settingforfull-scale
indication. (4.7 kΩ impedance)