Icom IC-7800 - Page 182

12-26
12
SET MODE
Selects whether or not to allow Remote stations to
select stereo sound. (default : 1ch)
When you select “1ch” (monaural), Remote stations
cannot program “2ch” (stereo).
If the Remote station selects “2ch,” stereo output
(L=Main band; R=Sub band).
Selects whether or not to allow Remote stations to
send the modulation audio. (default : ON)
•ON: The Remote stations send the modulation
audio.
•OFF:TheRemotestationsdonotsendthemodula-
tion audio.
Selects the limitation of the modulation audio sam-
pling rate that Remote stations can adjust.
8 kHz, 12 kHz, 16 kHz, 24 kHz and 48 kHz are se-
lectable. (default: 8 kHz)
Higher sampling rates will improve the audio quality.
However, they also increase the amount of data,
which can cause voice delay or jumpiness, depend-
ing on the network condition.
Lower sampling rates will decrease the audio quality.
However, they also decrease the amount of data.
Sets the transmit audio codecs that Remote stations
can select.
LPCM 8 bit, u-law 8 bit and LPCM 16 bit are select-
able. (default: LPCM 8bit, u-law 8bit, LPCM 16bit)
■ Others set mode (continued)
Enters the Network Radio name of up to 16 charac-
ters. The name displays on an RS-BA1’s Remote
Utility.
DO NOT use the duplicated name on your network.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
zPush[F-5•EDIT]toentertheNetworkRadioName
Edit mode.
x Rotate the main dial to input a Network Radio
Name of up to 16 characters.
 •Push[ABC]or[abc]totoggleupperandlowercaselet-
ters.
 •Push[123]or[Symbol]totogglebetweennumerals
and symbols.
 •Push[F-1•t]or[F-2•u] for cursor movement.
 •Push[F-3•DEL]todeletetheselectedcharacter.
cPush[F-5•SET]toset.
Selects the limitation of the received audio sampling
rate that Remote stations can adjust.
8 kHz, 12 kHz, 16 kHz, 24 kHz and 48 kHz are se-
lectable. (default: 16 kHz)
Higher sampling rates will improve the audio quality.
However, they also increase the amount of data,
which can cause voice delay or jumpiness, depend-
ing on the network condition.
Lower sampling rates will decrease the audio quality.
However, they also decrease the amount of data.
Sets the received audio codecs that Remote stations
can adjust.
LPCM 8 bit, u-law 8 bit and LPCM 16 bit are select-
able. (default: LPCM 8bit, u-law 8bit, LPCM 16bit)