Icom IC-7800 - Page 181

12-25
12
SET MODE
Register the Users ID to allow them to remotely ac-
cess the IC-7800. The IC-7800 can register three
users to Network User1 ID to Network User3 ID.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
See the Network User1 ID on the previous page for
setting details.
•YoucannotregisterthesameIDwithUser1orUser3,if
the ID is already registered.
Register the Users ID to allow them to remotely ac-
cess the IC-7800. The IC-7800 can register three
users to Network User1 ID to Network User3 ID.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
See the Network User1 ID on the previous page for
setting details.
•YoucannotregisterthesameIDwithUser1orUser2,if
the ID is already registered.
Register the password for the Network User2 ID. See the Password of Network User1 ID on the previ-
ous page for setting details.
Register the password for the Network User3 ID. See the Password of Network User1 ID on the previ-
ous page for setting details.
Selects the administrator setting YES or NO for Net-
work User1 ID. (default: NO)
When this item is set to “YES,” the Remote station
can terminate a connection between another Remote
station and the IC-7800.
Selects the administrator setting YES or NO for Net-
work User2 ID. (default: NO)
When this item is set to “YES,” the Remote station
can terminate a connection between another Remote
station and the IC-7800.
Selects the administrator setting YES or NO for Net-
work User3 ID. (default: NO)
When this item is set to “YES,” the Remote station
can terminate a connection between another Remote
station and the IC-7800.
■ Others set mode (continued)