13
OTHER FUNCTIONS
13-13
Transceiver-to-Transceiver cloning using an SD card (Continued) D
Touch [YES]. y
• While saving, a progress bar is displayed, and then the
“SD CARD” screen is displayed after the save is com-
pleted.
Touch [MENU]. u
• Closes the Menu screen.
RemovetheSDcardfromthemastertransceiver,2.
andtheninsertitintothesubtransceiver.
Hold down the master transceiver’s [ i
] to turn OFF
the power.
Remove the SD card from the master transceiver. o
Power OFF
Push
Pull out
Push in the SD card
until a click sounds.
!0 Insert the SD card into the sub transceiver, then hold
down the sub transceiver’s [ ] to turn ON the pow-
er.
NEVER forcibly or inversely insert the card.
It will damage the card and/or the slot.
Cloning function
Loadingthesettingdataintothesubtransceiver.3.
!1 Touch [MENU].
!2 Touch “Load Setting.”
(SD Card > LoadSetting)
• If the item is not displayed, touch [∫] or [√] one or more
times to select another page.
!3 Touch the desired setting file.
!4 Touch the desired content to load it.
• ALL: Loads all memory channels,
item settings in the menu list
and the repeater list into the
transceiver.
• Except My Station: Loads all memory channels, the
repeater list, and item settings
in the Menu screen except MY
call signs, into the transceiver.
• Repeater List Only: Loads only the repeater list into
the transceiver.
• The “Keep ‘SKIP’ setting in Repeater List?” appears.
!5 Touch “YES” or “NO.”
• When “Yes” is selected, the skip setting of the repeater
list is retained. (p. 7-29)
To Next Page
Loading...
Need help?
General
