Icom ID-52A

17
OPTIONS
17-6
When using an application
D Download procedures (Android device)
1. Turn ON your Android device.
2. Touch “Play Store.”
3. Enter the application’s name in the search field.
L Do not abbreviate the application name to be sure to
find it.
4. Touch “ .”
• The application’s name will be displayed as the
search result.
L If your Android device does not support the
application, its name may not appear on the search
result.
5. Touch the application to install.
• Displays the introduction screen of the application.
6. Touch <INSTALL> .
• Installation starts.
• After finishing the installation, the icon is displayed on
the screen.
DDownload procedures (iOS device)
1. Turn ON your iOS device.
2. Touch “App Store.”
3. Enter the application’s name in the search field.
L Do not abbreviate the application name to be sure to
find it.
4. Touch “ .”
• The application’s name will be displayed as the
search result.
L If your iOS device does not support the application,
its name may not appear on the search result.
5. Touch the application to install.
• Displays the introduction screen of the application.
6. Touch <GET>.
• Installation starts.
• After finishing the installation, the icon is displayed on
the screen.
DWhen using a USB cable
Android device
with the USB
host function
To a USB portTo the [USB] port
USB cable

L Connect the USB micro-B connector (for the OPC-2417:
with the white tube) to the transceiver and the other
connector to an Android device.
NOTE:
• Turn OFF the transceiver before connecting or removing
the cable.
• When an Android device is connected, the USB
connection indicator (
) is displayed on the
transceiver. If the indicator is not displayed, enable your
Android device to detect the USB device.
L No operation is required on a mobile device that
support automatic detection of the USB devices.
• When using RS-MS1A, confirm the following items are set.
([MENU] > SET > Function > CI-V)
Set “CI-V Address” to the value same as the RS-MS1A
side. (Default: A6)
L 
(Default: Transceiver[A6])
Set “CI-V Transceive” to “ON.”
([MENU] > SET > Function > USB Serialport Function)
Set “USB SerialPort Function” to “CI-V (Echo Back OFF).”
([MENU] > SET > Function > USB Connect)
Set “USB Connect” to “Serialport.”
• When using Access Point mode, RS-MS1A cannot be
used.
• Remove the USB cable when you do not use the cable.
Otherwise, the battery will be quickly exhausted.