17
OPTIONS
17-8
Connecting an Android™ device to the transceiver through Bluetooth
®
DConnection
This section describes how to connect an Android
device to the transceiver, using the RS-MS1A
application.
Before connecting, pair the transceiver with the
Android device. (p. 17-7)
L When using the ST-4001A application, the transceiver
and Android device are automatically connected while
transferring a picture.
Step 1. Preparing for the connection (Transceiver)
[MENU] > SET > Function > CI-V > CI-V Transceive
Set “CI-V Transceive” to ON to control the transceiver
and the RS-MS1A with CI-V commands.
Step 2. Starting the RS-MS1A (Android device)
Touch the RS-MS1A to start.
L See page 17-6 for details on downloading the RS-MS1A.
Step 3. Connecting to the transceiver
(Android device)
Touch the transceiver’s Bluetooth unit name displayed
on the RS-MS1A.
• Starts to connect.
L When your call sign has not been entered in the
transceiver, you should enter it before you connect.
L After the connection has been made, the transceiver
displays “
MMM Connected.,” and the Bluetooth icon is
displayed.
Displayed
L ” is displayed.
TIP: To connect to the Android device from the
transceiver
When the RS-MS1A is started on the Android device,
you can connect to the device from the transceiver.
[MENU] > SET > Bluetooth Set > Pairing/Connect
1. Push [MENU].
2. Select “Bluetooth Set” in the SET menu.
3.
4. Select the Android device name displayed in the
pairing list.
5. Select “YES.”
• Displays “MMM Connecting...”
( “
MMM” is the Bluetooth name of the Android
device.)
L
” is
displayed on the data device icon.
NOTE: If you cannot connect, check that the same
CI-V address is set in the transceiver and the RS-
MS1A.
You can see the CI-V setting as described below:
Transceiver
“CI-V Address” in the MENU screen.
([MENU] > SET > Function > CI-V > CI-V Address)
(Default: A6)
RS-MS1A:
(Default: Transceiver[A6])
Device name
Displayed while connecting
To Next Page
Loading...
