ID Technology 250 - Applicator Set up; Print Engine Set up; Test Print Engine

P
RINT
E
NGINE
S
ET
U
P
(S
ATO
)
Print Darkness: Print Speed:
Pitch Direction: Pitch Offset:
Zero Slash: Auto Online:
Vertical Offset: Horizontal Direction:
Horizontal Offset: Gap (label):
Gap (liner): Input:
DSW1 L
AY
O
UT
DSW2 L
AY
O
UT
DSW3 L
AY
O
UT
On On On
Off Off Off
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
P
RINT
E
NGINE
S
ET
U
P
(Z
EBRA
)
Print Mode Host Port
Media Type Baud
Sensor Type Data Bits
Print Method Parity
Print Width Stop Bit
Label Length Host Handshake
Max Length Network ID
Ribbon Tension Communications
Media Power Up Control Prefix
Head Close Format Prefix
Back Feed Delimiter Char
Head Test Count ZPL Mode
Head Resistor Label Top
Web Sensor Left Position
Media Sensor Verifier Port
Ribbon Sensor Applicator Port
LCD Adjust Resolution
Firmware Configuration
Memory B: Memory
T
EST
P
RINT
E
NGINE
(Sato) Print a test label using the User Test Print mode.
(Zebra) Print a test label using the PAUSE Key Self Test.
Is printhead balanced? YES NO
Are there any printhead elements out? YES NO
Check for ribbon wrinkle? YES NO
(Sato) Print a test label for printer configuration using the Factory Mode test print.
(Zebra) Print a test label for printer configuration using the CANCEL Key Self Test.
Is the label attached to back of this page? YES NO
Send label format to printer.
A
PPLICATOR
S
ET
U
P
Has label/web path been adjusted? YES NO
Has vacuum system been adjusted? YES NO
Has tamp pad height been adjusted for proper label feed? YES NO
Check to make sure that the tamp assemblies are not binding YES NO
Verify tamp assembly fasteners are tight and apply Loctite. YES NO
Applicator height sufficient to allow all products to pass underneath? YES NO