ID Technology 250 - Default Chapter; Table of Contents

Model 250
Printer Applicator
Operators/Technical Manual
Page 1 of 2
The 250 Label Applicator
Table Of Contents
Page
Serial Numbers page
The Manual
The Applicator
Section One
General Specifications
General Specifications…………………………………………………………………. 1-1
Packaging your RA……………………………………………………………………... 1-5
Section Two
Component Location and Identification
Front View……………………………………………………………………………….. 2-1
Rear View……………………………………………………………………………….. 2-1
Tamp Module…………………………………………………………………………… 2-4
Pneumatics……………………………………………………………………………… 2-5
Unwind Assembly………………………………………………………………………. 2-6
Rewind Module…………………………………………………………………………. 2-7
Electronics Module……………………………………………………………………… 2-8
Air-Assist Tube Module…………………………………………………………….…. 2-9
Low Label Sensor Assembly…………………………………………………………... 2-9
Tamp-Jet Pneumatic Assembly……………………………………………………….. 2-10
T-base Stand Assembly...……………………………………………………………… 2-11
Section Three
Installation
Unpacking and Setting Up the Machine……………………………………………… 3-1
Electronics Module……………………………………………………………………… 3-3
Low Label Sensor………………………………………………………………………. 3-4
Optional Flashing Beacon……………………………………………………………… 3-5
Label Threading (SATO)………………………………………………………………. 3-6
Label Threading (ZEBRA)…………………………………………………………….. 3-8
Ribbon Threading (ZEBRA) Print Engine …………………………………………... 3-12