ID Technology 250 - Menu Tree

Model 250
Printer Applicator
Operators/Technical Manual Section Five
Section 5 Page 3 of 18
Menu Tree
• Status Menu (5-16)
o Displays all set parameters
• Recall Setup (5-14)
o 1
o 2
o 3
o Factory
• Dwells/Delays (only displayed if “Delay Access” is set to “Yes” in Security) (5-14)
o Delay Apply
 Time Value in mS
• Password Entry (5-17) (items below are at main level if security disabled)
o Print Sequence (5-17)
 Normal
 Reverse
 Data Driven
o Apply Mode (5-10)
 Tamp
 Tamp Jet
 Air Jet
 Reverse Tamp Jet
o Vacuum Mode (5-16)
 Normal
 Conserve Air
o Outputs (5-12)
 Output 1, Output 2, Output 3, Output 4
• Label Low
• Ribbon Low