Model 250
Printer Applicator
Operators/Technical Manual Section Five
Section 5 Page 17 of 18
Password Entry / Security
The security menu gives users the ability to limit access to the parameters of the
Model 250. At the most limited setting, the operator only has the ability to view the
status menu and recall any of the four saved setups. If it is enabled, the operator
may also have the ability to change the Delay Apply value in order to alter the
label position on the product. All other functions require a PIN number to be
entered before access is allowed. Once logged in, pressing the
key several
times to back down to the Password Entry menu will effectively log out of the
protected area.
Password Entry – Here, the user must enter the correct PIN. By pressing the
up and down arrow keys, each digit can be changed from 1 to 3. After setting
the first digit, pressing the key will allow the next digit to be changed. After
the fourth digit is set, pressing the key will validate the entry and either allow
or deny access. The default PIN when shipped from the factory is 1231. If you
forget your PIN number, you will need to call for a service technician or return
the module to the factory.
Change Pin – Once logged in, you have the ability to select a different PIN for
the system. By using the same method as Password Entry above, select a
new four digit PIN combination.
Delay Access – This menu item lets the user determine if the Delay Apply
setting can be altered without requiring the PIN number. When set to Yes,
there will be an additional item at the main menu level to access the Delay
Apply setting. This setting is saved with each setup and can be set different for
each of the four saved slots.
Enable Security – This menu item turns the security feature on or off. When
set to “Yes”, the PIN is required to access most settings.
Keys to remember about Delay Access:
• Changing the values here will not affect stored setups. To apply
the change to a stored setup, it is necessary to log in and re-
save the appropriate setup.
• The Delay Access setting is stored with each setup. It is
possible to allow access for some setups and deny access for
others.
To Next Page
Loading...