ID Technology 250 - Page 3

Model 250
Printer Applicator
Operators/Technical Manual
Page 2 of 2
Applicator Installation Check List.…………………………………………………….. 3-14
Print Engine Set Up (Operator Notes).……………………………………………….. 3-15
Applicator Set Up Check List.……………………………………………………….… 3-16
Final System Check.……………………………………………………………………. 3-17
Tools Required.…………………………………………………………………………. 3-18
Section 3A Installation of Tamp-Jet Module……………………………………..
Section 3B Installation of System Status Module………………………………
3A-1
3B-1
Section Four
Operational Components
Tamp Application……………………………………………………………………….. 4-1
Pneumatics Gauges……………………………………………………………………. 4-5
Changing Tamp Pads…………………………………………………………………... 4-6
Section Five
Operating Procedures
Print Engines…………………………………………………………………………….. 5-1
Using The Menus……………………………………………………………………….. 5-2
Menu Tree……………………………………………………………………………….. 5-3
Print Sequence………………………………………………………………………….. 5-6
Apply Mode……………………………………………………………………………… 5-10
Outputs…………………………………………………………………………………… 5-12
Save Set Up……………………………………………………………………………... 5-14
Recall Set Up…………………………………………………………………………… 5-14
Dwells And Delays……………………………………………………………………… 5-14
Status Menu……………………………………………………………………………... 5-16
Vacuum Mode…………………………………………………………………………… 5-16
Password Entry / Security……………………………………………………………… 5-17
Section Six
Maintenance and Trouble Shooting
Dimensions of Applicator………………………………………………………………. 6-1
Electrical connections and connector pinouts…………...…………………………... 6-3
Electronic Module Board Layout………………………………………………………. 6-4
Troubleshooting Guide. ………….…………………………………………………….. 6-9
Timing Cycles……………………………………….………………………………… 6-16
Appendix One
250 Bill of Materials and Parts Drawings
Appendix Two
Correctly Setting Tamp Pad to Peel Edge