xiv CUSA EXcel Ultrasonic Surgical Aspirator System Service Manual
Figure 11-16. Pulling the strain relief bushing away from the manifold bracket 11-25
Figure 11-17. Removing the manifold bracket from the console 11-25
Figure 11-18. Removing the suction control valve from the manifold bracket 11-
26
Figure 11-19. Removing the suction hose and clamp from the suction control
valve
11-27
Figure 11-20. Removing the suction tube and clamp from the “T” fitting 11-30
Figure 11-21. Pulling the split bushing away from the manifold bracket 11-30
Figure 11-22. Disconnecting cables from the suction pump to the suction pump
controller card
11-31
Figure 11-23. Removing the suction tube and strain relief bushing from the
suction pump and its wires
11-33
Figure 11-24. Removing the suction pump from its bracket mount 11-33
Figure 11-25. Attaching the suction pump motor to its mounting bracket, making
sure to center the pump on the bracket
11-34
Figure 11-26. Removing the cable clamps and screws from the suction pump
controller card
11-36
Figure 11-27. Removing the irrigation pump bezel 11-39
Figure 11-28. Removing the suction pinch valve 11-39
Figure 11-29. Removing the irrigation pump bezel 11-41
Figure 11-30. Removing the irrigation pump head 11-42
Figure 11-31. Disconnecting the irrigation pump gear motor from the control card
11-43
Figure 11-32. Replacing the gear motor/pump head coupler on the motor drive
shaft
11-44
Figure 11-33. Replacing the handpiece flow sensor 11-47
Figure 11-34. Removing the end bell and tubing from the cooling water pump
head
11-50
Figure 11-35. O-rings on cooling water reservoir connectors 11-51
To Next Page
Loading...
Need help?
General
