Intermec EasyCoder PM4i - Page 111

Chapter 10 — Troubleshooting
EasyCoder PM4i Printer User’s Guide (Fingerprint Version) 95
Incorrect edge
guide adjustment
Adjust Chapter 4
Too strong
printhead
pressure
Adjust Chapter 11
No thermal
transfer printout
Ink-coated side
does not face
media
Reload ribbon Chapter 5
Media feed not
working properly
Changed media
characteristics
Press the Print
button
Chapter 4
Wrong label rest
dots parameter
Check/change Chapter 6
Wrong Media
Type parameter
Check/change Chapter 6
Wrong LSS
position
Check/change Chapter 11
Dirty sensors Clean media
guides
Chapter 10
Faulty sensors Replace Call Service
Symptoms and Possible Causes (continued)
Symptom Possible Cause Remedy Refer To