Itotec SC115Z - Page 49

5
tighten the knife handoles.
on the leveling block.
Set the knife under the knife carrier.
Install the hanging bolts.
Loose the knife handles.
the knife.
Remove the knife holders.
up/down screw and move the lift plate up/
down to align with the hanging screw hole.
Raise the knife until the bolt hole is aligned.
Turn the lifting screw toward clockwise, raise
How to change the knife
Install the knife holders, with the taller one
on the left and shorterone on the right, and
While holding the knife handles, eract the knife
Insert the T up/down wrench into the knife
When removing or installing the holder or
handle from/to the knife, be careful of the
cutting edge of the knife.
Otherwise injuries will be caused.
How to install the knife (Knife lifter） 2
6.
10.
When slidng the knife holder on the surface
plate, be careful not to make the cutting
edge into contact with the main body.
Otherwise the cutting edge will be chipped.
7.
6
6
6
6
8.
9 .
When using the knife handle, be careful not
to allow fingers to slip due to oil or rhe like.
Otherwise injuries will be caused.
11.
12.
13.
14
11
11
14
12
9
14.
CAUTION
CAUTION
CAUTION
If the knife bolt hole is not aligned due to an
inclined knife or the like, use the Allen wrench
for knife installation to correct.
49