In the right frame the file content of the software version 1.0.6.5 (in this example) on the SD
flash card is shown.
The path on the flash card to software version 1.0.6.5 must be
X:\UnisabIII\updates\1_0_6_5.
In the Update menu, you have four (five) options:
1.
F1
/Transfer - to transfer (configuration) files from Unisab III to SD card or
/Enter - to transfer software files from SD card to Unisab III
2.
F2
/Position - cursor up
3.
F3
/Position - cursor down
4.
F4
/Refresh the picture, e.g. if you have inserted another SD card
F2
and
F3
are used to navigate up and down in the file list.
F4
is used to refresh the file list.
To transfer (download) the configuration files from Unisab III to the flash card, press
F1
/
Transfer and follow the instruction on the screen.
Before inserting the SD card make sure it contains the following path: E:\UnisabIII\updates
\1_0_6_5. Note that the drive letter E:\ and the version number 1_0_6_5 are examples only
and may very well be different from yours.
In this example the path: E:\UnisabIII\updates\1_0_6_5 on the SD card is empty, it does not
contain any files.
Press the
F1
/Transfer button to download configuration and setting files from Unisab III to
the flash card.
Unisab III (boot) and communication set-up
252/319
Engineering manual - Unisab III 1.10
001930 en 2014.09
To Next Page
Loading...
Need help?
General
