Juniper PTX10001-36MR - Page 101

Figure 32 on page 92 shows the locaon of the DC input current selector (somemes called the
DIP switch ).
Figure 32: PTX10001-36MR DC Power Supply
1— Ejector lever 4— Handle
2— Status LED 5— Terminal block cover
3— DC input current selector (DIP switch)
4. Open the cable manager latch on the terminal block cover of a power supply.
5. Use a Phillips screwdriver to loosen the screw holding the cable manager latch to the power supply
terminal block cover. See Figure 33 on page 92.
Figure 33: Loosen the Cable Manager Latch
6. Remove the cable manager bracket to expose the four terminal studs.
92