Juniper PTX10001-36MR - Page 139

Table 35: PTX10001-36MR System Alarm Messages (Connued)
Component Alarm Type CLI Message Recommended Acon
Fan I2C Failure
Check the system log for one of the
following messages and report the
error message to customer support:
• CM ENV Monitor: Get fan speed
failed.
• fan-number is NOT spinning @
correct speed, where fan-number
can be 0, 1, 2, 3, 4, or 5.
Fan fan-number Not Spinning
Remove and check the fan module
for obstrucons, and then reinsert
the fan module. If the problem
persists, replace the fan module.
Minor (yellow)
Fan/Blower Absent
Check the system log for the
message fan-number Absent, where
fan-number
can be 0, 1, 2, 3, 4, or 5.
Install the fan module.
Power supplies Major (red)
PEM pem-number Airflow not matching
Chassis Airflow
Replace the power supply with a
power supply that supports the
same airow direcon as the
chassis.
PEM pem-number I2C Failure
Check the system log for one of the
following messages and report the
error message to customer support:
• I2C Read failed for device
number , where number can be from
123 throgh 125.
• PS number : Transitioning from
online to offline, where power
supply (PS) number can be 0 or 1.
130