Juniper PTX10001-36MR - Page 17

How to Congure the QSFP28 Ports for 10-Gbps, 25-Gbps, and 40-Gbps Speeds | 12
Operang in a xed core router conguraon, the PTX10001-36MR features exible interface
conguraon opons. The port panel has 24 double density quad small-form factor pluggable (QSFP56-
DD) ports that support data rates of 10-Gbps, 25-Gbps, 40-Gbps, 100-Gbps, and 400-Gbps and 12
quad small form-factor pluggable (QSFP28) ports that support data rates of 10-Gbps, 25-Gbps, 40-
Gbps, and 100-Gbps.
Figure 3 on page 8 shows the PTX10001-36MR port panel.
Figure 3: PTX10001-36MR Port Panel
1—
ESD grounding point
6—
RJ-45 console and me of day (TOD) port
2—
12 network ports—QSFP28 cages
7—
Oine buon. Pressing and holding this
buon for more than 4 seconds turns the
device o. Pressing the buon again turns
the device back on.
3—
Clock connectors (10 MHz and 1 PPS)
8—
Reset buon (do not use unless directed by
JTAC)
4—
RJ-45 management port (10 Mbps/100
Mbps/1000 Mbps)
9—
24 network ports—QSFP56-DD cages
5—
USB port (USB 2.0 standard)
QSFP56-DD Network Ports
The PTX10001-36MR has 24 double density quad small-form factor pluggable (QSFP56-DD) sockets
that are congured as 400GbE ports by default.
The QSFP56-DD network ports support:
8