Juniper PTX10001-36MR - Page 96

• Screwdriver appropriate for the M6 x 10 mm screws.
To connect a grounding cable to the PTX10001-36MR:
1. Aach a grounding cable to earth ground (such as the rack in which the PTX10001-36MR is
mounted) and then aach it to the chassis grounding point. Figure 29 on page 87 shows the
locaon of the chassis grounding point.
Figure 29: PTX10001-36MR Grounding Points
2. Secure the grounding lug to the protecve earthing terminal with the washers and screws. See Figure
30 on page 87.
Figure 30: Connect a Grounding Cable to a PTX10001-36MR Device
3. Dress the grounding cable and ensure that it does not touch or block access to other device
components and that it does not drape where people could trip over it.
87