Juniper SRX300 Series - Page 122

Routing Engine 0 RE BIOS 0 3.0 3.6 OK
Routing Engine 0 RE BIOS Backup 1 3.0 3.6 OK
4. Upgrade the firmware on the device:
user@host > request system firmware upgrade pic fpc-slot <fpc-slot-number>
Part Type Tag Current Available Status
version version
FPC 2
PIC 0 MWAP_FW 1 1.1.8 1.2.1 OK
Perform indicated firmware upgrade ? [yes,no] (no) yes
Firmware upgrade initiated, use "show system firmware" to monitor status.
5. Verify that the firmware is upgraded successfully. The status should show OK.
user@host > show system firmware
Part Type Tag Current Available Status
version version
FPC 2
PIC 0 MWAP_FW 1 1.1.8 1.2.1 PROGRAMMING (0%)
Routing Engine 0 RE BIOS 0 3.0 3.6 OK
Routing Engine 0 RE BIOS Backup 1 3.0 3.6 OK
user@host > show system firmware
Part Type Tag Current Available Status
version version
FPC 2
PIC 0 MWAP_FW 1 1.1.8 1.2.1 PROGRAMMING (25%)
Routing Engine 0 RE BIOS 0 3.0 3.6 OK
Routing Engine 0 RE BIOS Backup 1 3.0 3.6 OK
user@host > show system firmware
124