Chapter 2. The Validator AVS Hardware
Kaye Validator AVS User’s Manual 20
2.2.5 Internal Memory
The Validator AVS is designed to write data to internal memory during sensor calibration
and qualification studies. Qualification data resides in internal memory until it is read out to
a console. Up to 10 studies are stored in the internal drive.
The Validator AVS provides over 4 GB of internal memory to maintain qualification data
during a study. The final study data is stored in the internal 32GB solid state memory. The
32GB solid state memory is mirrored to a 32GB SD-card memory that can get extracted
by a Kaye technician for emergency recovery.
The Validator AVS allows you to scan data at 12 inputs per second per SIM slot during
the qualification study. If SIM slot 4 is used the storage rate is reduced to 2 seconds
allowing the maximum of 36 inputs per second or 48 inputs every 2 seconds.
Compared to the Kaye Validator 2000 there is no fast scan or slow scan available
anymore.
To Next Page
Loading...
