Chapter 6. Defining Study Setups
Kaye Validator AVS User’s Manual 63
Chapter 6. Defining Study Setups
Before you can run a qualification study, you must use the Kaye Validator AVS software to
create or modify a setup. A setup defines everything required to calibrate sensors and run a
qualification study.
Note: To create or modify a setup, you must have permissions established by your System
Administrator in the Admin menu (User Management tab).
You access setups from the Asset Details screen, through the Setup pane. When you create a
setup, you:
• Define the sensors you are going to use in the study
• Assign sensors to groups and generate a wiring diagram
• Specify calculations and define group events to be monitored during the qualification study
• Specify calibration and verification setpoints
• Specify temperature stability and deviation criteria for sensor calibration and verification
• Specify start and stop conditions for qualification and exposure cycle
• Define the output relays
After you have created and saved your setup, you can calibrate sensors and run a
qualification study.
To Next Page
Loading...
