Chapter 6. Defining Study Setups
Kaye Validator AVS User’s Manual 75
6.9 Specifying Qualification Study Conditions
• Specify the conditions that control your qualification study on the Qualification
Parameters screen. From this screen you specify:
• Qualification start/stop conditions - used to start and stop the qualification cycle
manually or automatically
• Exposure start/stop conditions - used to start and stop the exposure cycle manually or
automatically
• Data storage options - the rates at which data is written to disk during a qualification run
• Output relay - the events that activate the two independent output relay
When you have finished, press Review to check your entries and save the setup.
To Next Page
Loading...
